RacePrecision Site Admin
Joined: 19 Jul 2006 Posts: 101
|
Posted: Fri Feb 22, 2008 9:43 pm Post subject: BMW Z4 M coupe Ram Air Installation Instructions |
|
|
Typical Install time: 10-15min
Tools needed:
-Long philips screw driver
-finger nail to peel double sided foam tape.
-pliers or strong fingers
-flashlight or work lamp
Step 1-3:
Unlike the M5 or M6, there isn’t a way to de-press the kidney grill
clips. You will have to gently pull the driver side kidney grill off.
There are 4 main clips towards the corner of the grill so you will put
most of the pulling effort in those areas.
Once the grill is off, you will need to remove the stock intake
velocity stack/scoop. This piece is secured by 3 pins. The rear has two
pins which are part of this piece and will just pull out. The front pin
(pictured) is removed by pulling the push head outwards. Once it is
pulled out, the pin assembly will come out easily. After removing that
pin, pull the scoop/stack outwards then towards the passenger side (see
picture below).
Step3b
Peel the backing off the double sided foam tape on the RPi scoop
tab. The tape will help hold the scoop in place while you screw in the
self tapping screws. The tab does NOT have to line up to the tubing
wall (see picture). A long screw driver will work best.
Step 4-5
Once the scoop is in place, hold the kidney grill up to the opening
to make sure there is enough clearance. Use the self tapping screws
(provided) to secure the scoop in place at the main mounting tab. **DO
NOT OVERTIGHTEN. ONLY SCREW IN ENOUGH TO HOLD THE SCOOP IN PLACE.**
Step 6
Once the back or main tab screws are in place, tap the bottom screw
in. You may want to bring out the flashlight at this time to help you
find the hole. **DO NOT OVERTIGHTEN. ONLY SCREW IN ENOUGH TO HOLD THE
SCOOP IN PLACE.**
If you get stuck or have any questions, please call us at 562-630-5966. _________________ Race Precision Inc.
7029 Marcelle Street
Paramount, CA 90723
www.raceprecision.com
Tel:562-630-5966 |
|